Rocky Mountain Radar RMR-8RDS - Manual (Page 5)

Detour the cable away from moving parts and hot surfaces
(Radiator, hoses, engine, etc.) and fasten secure with the
supplied cable ties.
Route the cable into the vehicle’s interior.
Pull the cable through firewall and plug into jack marked
“Front” of the Control module.
Front Scrambler Cable
Route scrambler cable from the front and secure with supplied
cable ties.
Detour the cable away from moving parts and hot surfaces
(Radiator, hoses, engine, etc.) and fasten secure with the
supplied cable ties.
Route the cable into the vehicle’s interior.
Pull the cable through firewall and plug into jack marked
“AUX” of the Control module.
NOTE: Keep the scrambler cable away from any areas in the
engine compartment that may become very hot. Cable ties are
provided to secure the scrambler cable at various points in the
engine compartment.
Rear Scrambler Cable
Route scrambler cable from the rear through trunk compartment
and secure with supplied cable ties.
Route the cable into the vehicle’s interior.
Pull the cable through and plug into jack marked “Rear” on the
Control module.
Test
After all components are installed correctly, turn the Control
module on by pressing the power button. The Self-Test mode
will run every time the Control module is powered on.
B
A
C
G
F
D
E
A
FRONT ANTENNA B
C
CONTROL MODULE
D
FRONT ANTENNA CABLE
F
FRONT SCRAMBLER MODULE
G
REAR SCRAMBLER MODULE
FRONT SCRAMBLER MODULE CABLE
REAR SCRAMBLER MODULE CABLE
E
5