Rocky Mountain Radar KAT-TRAXX - Manual (Page 9)

Pressing the UP or DOWN button once causes the display to
show average horsepower between the two speeds chosen in
setup.
Pressing the UP or DOWN button again shows the peak
horsepower reached during the measurement.
�1/4MILE MODE / 400M MODE
Pressing Start Button to perform an internal calibration. After
the calibration is completed successfully, its display shows
'READY' with blinking:
The measurement begins as soon as the vehicle starts moving
and the display shows current elapsed time. At the end of 1/4
mile (400m), the speed reached is displayed.
Pressing the UP or DOWN button causes the display to show
the time for 1/4 mile (400m).
Pressing the UP or DOWN button causes the display to show
average horsepower between the two speeds chosen in setup.
Pressing the UP or DOWN button shows the peak horsepower
reached during the test.
�G-FORCE
Pressing the MODE button until the display shows G FORCE.
The display shows the number of horizontal and forward Gs.
The right indicator is sideways acceleration with the arrow
indicating direction. The left is forward acceleration. The ‘+’
shows up when speed is increasing and ‘-’ shows up when
speed is decreasing.
�ERROR MESSAGES WITH VOICE
∙ The display scrolls with 'TILT ERR - Adjust Mounting' with
voice of 'Tilt error, adjust mounting'
→ Please check its mounting and calibrate again. It should
be tilted more than 30 degrees during calibration.
∙ The display scrolls with 'ERR - Must be stationary' with voice
of 'Must be stationary'
→ There is vibration during calibration.
∙ The display scrolls with 'DecelerationERR' with voice of
'deceleration error'
→ The speed should be decelerated during measurement.
Please accelerate the vehicle speed during measurement.
17
TRAXX
OWNER’S MANUAL
16
TRAXX
OWNER’S MANUAL
H P a v g 2 8 9 P S a v g 2 9 3
9 6 M P H
1 4 . 3 5 s e c
1 5 4 K P H
H P a v g 2 8 9 P S a v g 2 9 3
H P p k 3 0 6
+ . 2 4 � . 3 4
P S p k 3 1 0
H P p k 3 0 6 P S p k 3 1 0
R E A D Y