Rocky Mountain Radar KAT-TRAXX - Manual (Page 14)

FACTORY RESET
Press DOWN button for five (5) seconds to enter Factory
Reset. When the display is blinking ‘RESET’, press START
button to reset all data to factory default. If you do not want
factory reset, press MEMORY button to exit.
- Clear all measurement data
- Set-up items
- Calibration data
Factory reset default:
a. BACKLIT ON
b. SOPRANO
c. COMBO MODE
d. HIGHWAY
e. VOICE ON
f. VG-2 ON
g. LASER SCRAMBLER ON
h. SETUP DATA DEFAULT
i. CALIBRATION DATA DEFAULT
j. SAFETY ALARM ON
REPLACING FUSE
To replace the fuse, unscrew the top of the plug. Remove and
check the fuse to see if it has blown. If it has, replace it.
SPECIFICATIONS
RADAR
Receiver Type: Dual conversion superheterodyne
Antenna Type: Linear polarized. self-contained
Antenna
Device Type: Frequency discriminator
Frequency of Operation: 10.525GHz/ ± 50MHz(X-Band)
24.150GHz/ ± 100MHz(K-Band)
34.700GHz/ ± 1,300MHz
(Ka Super Wideband)
LASER
Receiver Type: Pulsed laser signal receiver
Detector Type: Digital signal processor pulse width
discriminator
Optical Sensor: Dual convex condenser lens and high
speed photo diode detector
905
± 50 nanometers(nm)
ACCELEROMETER
Sensor: Tri-axis(X,Y,Z) ± 2G
GENERAL
Operating Temperature Range: -20 ℃ ~ +70 ℃
Storage Temperature Range: -30 ℃ ~ +100 ℃
Power Requirements: 12V to 15V DC, 150mA, negative ground
Dimensions: 1.2" (H) x 2.9" (W) x 4.6" (L)
Weight: 4.0 ounces
*Specifications are typical. Individual units might vary.
Specifications are subject to change without notice.
27
TRAXX
OWNER’S MANUAL
26
TRAXX
OWNER’S MANUAL