Poolmaster 59025 Above-Ground Pool Solar Heater User Manual
Page 9
8
R
L
(H)
T-CONNECTOR
(1)
T-CONNECTOR
• Once you’ve assembled the Diagram 4 components, insert the prepared end with side hose connector
into the other opening on the underside of the Solar Heater that you designated as the OUTGOING
opening. NOTE: ONCE YOUR SIDE HOSE CONNECTOR IS IN PLACE, MAKE SURE YOU TURN TO LOCK.
• Turn your Solar Heater over. You should now have your Solar Heater connected to an INCOMING hose
and OUTGOING hose.
• Connect the loose end of the Solar Heater’s
OUTGOING hose (1) to the left end of the last
component, (H) the T-connector.
Make sure the hose is pushed all the way to the
end of the adaptor. Tighten the hose clamp.
• With a new hose, attach one end to the adapter
on the top opening noted BYPASS TO POOL of
the 3-Way Bypass Valve (1) and the other end into
the center of the T-connector.
Make sure the hose is pushed all the way to the
end of the adaptor. Tighten the hose clamp.
SOLAR HEATER
FILTER PUMP SYSTEM
INCOMING
HOSE
POOL WATER
OUT
3-WAY
BYPASS
VALVE
T-CONNECTOR
(1)