Paragon 6133410 (120v) THE COOLER - Manual (Page 4)

ELECTRICAL REQUIREMENTS
This product requires a properly-grounded 120 volt supply with a 15 amp circuit. The Sno-Storm and The
Blizzard have a current draw of 5.7 amps; The Blast and The Cooler have a current draw of 5.3 amps.
(Export voltage is 230VAC.)
We recommend your Paragon Sno-Cone Machine be plugged directly into a dedicated outlet. Extension
cords may create a safety hazard and reduce its performance.
Be sure outlet accepts three (3) prong grounded plug. DO NOT use a three (3) prong to two (2) prong
adapter.
UNPACKING
Paragon carefully inspects each product during assembly and after completion to adhere to strict quality
guidelines, and packs it securely to ensure safe delivery to each of our customers. Be sure to carefully
remove all packing material and adhesive before any operation. Please examine your product to guarantee
all equipment has arrived, complete and in good condition.
If you believe that any damage may have occurred during shipment or parts may be missing, please
contact Paragon immediately for replacement.
FREQUENTLY ASKED QUESTIONS
How much will my sno-cone machine produce?
Your sno-cone machine was engineered to shave 500 lbs. of cube or chunk ice per hour.
Based on the ratio that a 1/2 lb. of ice will make a 6 oz. sno-cone, the Paragon Sno-Cone
Machine will yield 1000 sno-cones per hour.
How much syrup should I use to flavor my sno-cones?
One 6 oz sno-cone will take 2 ounces of syrup – cones will not hold more than that.
Can I use block ice to make sno-cones?
You can use block ice to produce sno-cones if you first break it down into pieces 3-4 inches
in size. Ice will not fit the horn if the pieces are too large.
OPERATING INSTRUCTIONS
Be sure equipment is connected to properly grounded 120 volt power supply with 15 amp circuit. (230 volts for
export models)
Shaving Ice
1. Turn POWER switch ON (Not used on The Cooler and The Blast).
2. Fill the ice horn with ice.
3. Press and hold the MOTOR switch to activate blades and begin shaving ice.
4. While holding MOTOR switch down, apply steady downward pressure to the ice pusher
5. Release the MOTOR switch when finished.
6. Repeat steps 2-5 for additional batches.
4