American Audio DX5R - Manual (Page 12)

DX5R™ Controls and Features Cont.
© American Audio ® - www.AmericanAudio.us - DX5R™ Instruction Manual Page 12
turntable use MM pick-up cartridges) may be connected to these jacks as long as the LINE LEVEL
SELECTOR SWITCH (31) is in the “PHONO 1” position. CD players or Tape Decks and other line
level instruments may be connected to these jacks as long as the LINE LEVEL SELECTOR SWITCH
(31) is in the “LINE 1” position. The red colored RCA jack represents the right channel input and the
white represents the left channel input. Input volume will be controlled by the channel two ROTARY
FADER (6).
40. CHANNEL 1: LINE INPUT JACKS - These Jacks are used for line level inputs. Connect CD
players or Tape Decks to LINE inputs. Line level musical instruments with stereo outputs such as
Rhythm Machines or Samplers should also be connected to LINE inputs. Turntables should only be
connected to “Phono” inputs. The red colored RCA jack represents the right channel input and the
white represents the left channel input. Input volume will be controlled by the channel one ROTARY
FADER (6).
41. CHANNEL 1: PHONO 1/LINE 1 INPUT JACKS - Use these jacks to connect either a phono
cartridge turntable or a line level device. The type of input device must directly reflect the mode of
the LINE LEVEL SELECTOR SWITCH (31). Turntables equipped with MM pickup cartridge (All DJ
turntable use MM pick-up cartridges) may be connected to these jacks as long as the LINE LEVEL
SELECTOR SWITCH (31) is in the “PHONO 1” position. CD players or Tape Decks and other line
level instruments may be connected to these jacks as long as the LINE LEVEL SELECTOR SWITCH
(31) is in the “LINE 1” position. The red colored RCA jack represents the right channel input and the
white represents the left channel input. Input volume will be controlled by the channel one ROTARY
FADER (6).
42. MICROPHONE 2 CONNECTOR - This jack is used to a connect a microphone to the mixer.
Connect you microphone via 1/4 inch (6.3mm) jack. The signal volume will be controlled by the MIC
2 VOLUME KNOB (16).
43. MICROPHONE 1 CONNECTOR - This jack is used to a connect a microphone to the mixer.
Connect you microphone via 1/4 inch (6.3mm) jack. The signal volume will be controlled by the MIC
1 VOLUME KNOB (3).