American Audio DX5R - Manual (Page 11)

power is shut off before change the position of the Line Level Selector Switch.
31. SUBWOOFER FREQUENCY LEVEL - This knob is used to adjust the subwoofer frequency
level. The frequency level output can range from 80Hz to 200Hz. This adjustment will only affect the
SUBWOOFER OUTPUT JACK (33).
32. SUBWOOFER OUTPUT JACK - This jack is used to send a mono subwoofer output signal to
a powered speaker or amplifier. Only connect a device that is designed to handle low frequencies
to this jack.
33. 1/4” JACK BOOTH OUTPUTS JACKS - These RCA jacks send a low current unbalanced out-
put signal and are controlled by the BOOTH LEVEL (22) volume control. These jacks should only be
used for shorter cable runs to signal processors or looping to another mixer.
34. CHANNEL 4: LINE 8 RCA INPUT JACKS - These Jacks are used for line level inputs. Connect
CD players or Tape Decks to LINE inputs. Line level musical instruments with stereo outputs such
as Rhythm Machines or Samplers should also be connected to LINE inputs. Turntables should only
be connected to “Phono” inputs. The red colored RCA jack represents the right channel input and
the white represents the left channel input. Volume will be controlled by the channel four ROTARY
FADER (6).
35. CHANNEL 4: LINE 7 INPUT JACKS - These Jacks are used for line level inputs. Connect CD
players or Tape Decks to LINE inputs. Line level musical instruments with stereo outputs such as
Rhythm Machines or Samplers should also be connected to LINE inputs. Turntables should only
be connected to “Phono” inputs. The red colored RCA jack represents the right channel input and
the white represents the left channel input. Volume will be controlled by the channel four ROTARY
FADER (6).
36. CHANNEL 3: LINE 6 INPUT JACKS - These Jacks are used for line level inputs. Connect CD
players or Tape Decks to LINE inputs. Line level musical instruments with stereo outputs such as
Rhythm Machines or Samplers should also be connected to LINE inputs. Turntables should only
be connected to “Phono” inputs. The red colored RCA jack represents the right channel input and
the white represents the left channel input. Input volume will be controlled by the channel three
ROTARY FADER (6).
37. CHANNEL 3: LINE 5 INPUT JACKS - These Jacks are used for line level inputs. Connect CD
players or Tape Decks to LINE inputs. Line level musical instruments with stereo outputs such as
Rhythm Machines or Samplers should also be connected to LINE inputs. Turntables should only
be connected to “Phono” inputs. The red colored RCA jack represents the right channel input and
the white represents the left channel input. Volume will be controlled by the channel three ROTARY
FADER (6).
38. CHANNEL 2: LINE 4 INPUT JACKS - These Jacks are used for line level inputs. Connect CD
players or Tape Decks to LINE inputs. Line level musical instruments with stereo outputs such as
Rhythm Machines or Samplers should also be connected to LINE inputs. Turntables should only be
connected to “Phono” inputs. The red colored RCA jack represents the right channel input and the
white represents the left channel input. Input volume will be controlled by the channel two ROTARY
FADER (6).
39. CHANNEL 2: PHONO 2/LINE 3 INPUT JACKS - Use these jacks to connect either a phono
cartridge turntable or a line level device. The type of input device must directly reflect the mode of
the LINE LEVEL SELECTOR SWITCH (31). Turntables equipped with MM pickup cartridge (All DJ
DX5R™ Controls and Features Cont.
© American Audio ® - www.AmericanAudio.us - DX5R™ Instruction Manual Page 11