MBRP S7230304 - Manual (Page 3)

S7230 © 10/11 PAGE 3 OF 4
7. Remove the Pinch Bolt from the Steering Shaft and lift the shaft assembly
off the Steering Rack. Swing the shaft out of the way.
Refer to Figure 6.
8. Disconnect both front O2 Sensor leads from the vehicle wiring harness.
9. Disconnect the wiring and remove the Starter Motor.
10. Use a block of wood under the Transmission Bell housing and
CAREFULLY lift the engine up off the Rubber Engine Mounts just enough
to be able to remove the Aluminum Engine Mounts from the Engine Block
on the driver and passenger side.
Refer to Figures 7, 8 and 9.
11. Remove the remaining M10 Flange Nuts securing the Exhaust
Manifolds to the Cylinder Heads from below.
Refer to Figure 10.
12. Remove the Exhaust Manifolds and the remaining manifold studs from
the Cylinder Heads.
Note: engine must be raised in order to remove the Exhaust Manifolds.
Figure 6
Figure 7
Figure 8
Figure 9
Figure 10