MBRP S7102 - Manual (Page 2)

S7102 © 12/12 PAGE 2 OF 4
2008-2013 SRT8 DODGE CHALLENGER
Removal of stock system:
1. Apply a penetrating lubricant liberally to all exhaust
fasteners, hangers and rubber insulators.
2 Remove the nuts from the flange on the rear of the muffler
(on the driver side). Remove the rubber insulator. Refer to
Figure 1.
3. Remove the two factory hangers by removing the hardware
on the driver side. Remove the driver side muffler and tail
pipe.
Refer to Figure 2.
4. Loosen the band clamps on the factory exhaust located in
front of the X-pipe. Refer to Figure 3.
5. Remove the two factory hangers by removing the
hardware on the passenger side. Remove the rubber isolator
behind the dual muffler. Remove passenger side exhaust
from the X-pipe back. Refer to Figure 4.
Figure 1
Figure 2
Figure 3
Figure 4