MBRP S5132 User Manual
Page 3
S5132 © 01/08
PAGE 3 OF 3
3. Install Muffler hangers into existing rubber insulators. Refer to
Figure 5.
4. Slide the 3 ½” Band Clamp over the Tail Pipe and install onto the
Muffler. Attach the tail pipe hanger to the existing rubber insulators.
Refer to Figure 6.
6. Install and adjust the Exhaust Tip to suit. Using a 17mm wrench
tighten the lock bolt located on the Exhaust Tip. Refer to Figure 7.
7. Align the exhaust as required. Starting at the front of the exhaust,
tighten all clamps and connections.
8. Check along the whole length of the exhaust system to ensure that
there is adequate clearance around the spare tire, fuel and brake lines
or any wiring. If any interference is detected relocate or adjust.
Congratulations! You are ready to begin experiencing the improved power, sound and driving
experience of your MBRP Inc. performance exhaust system. We hope you enjoy your purchase.
Figure 5
Figure 6
Figure 7