MBRP S5130 - Manual (Page 3)

S5130 © 6/13 PAGE 3 OF 4
Figure 5
3. Slide two 2 ½” Clamps over the outlets of the Muffler. Position
the Driver Side Over Axle Pipe over the axle and loosely attach it to
the Muffler. Install the Driver Side Over Axle Pipe hanger into the
factory rubber insulator. Repeat these steps for the Passenger Side
Over Axle Pipe. Refer to Figure 5.
4. Slide a 2 ½” Clamp over the Passenger Side Tail Pipe and install
onto the Passenger Side Over Axle Pipe. Refer to Figure 6.
5. Slide Driver Side Tail Pipe hanger into rubber insulator and
attach to the frame using fasteners provided. Refer to Figure 7.
Repeat steps 4 and 5 for the Passenger Side Tail Pipe.
6. Install and adjust the Exhaust Tip to suit. Reinstall the heat shield a
minor modification will be required. Trim Shield to fit with the Hanger
Assembly. Refer to Figures 7& 8.
Figure 6
Figure 7
Figure 8
Figure 9