MBRP S5130 - Manual (Page 2)

S5130 © 6/13 PAGE 2 OF 4
Figure 1
Removal of Stock System
1. Apply a penetrating lubricant liberally to all exhaust fasteners,
hangers and rubber insulators. Refer to Figure 1& 2.
2. Remove the clamp just after the Y-pipe.
3. Remove the clamp from the rear of the muffler.
4. Remove the stock exhaust from the existing rubber isolators and
remove the system from the vehicle.
5. Temporarily remove the spare tire and the heat shield around the
spare tire. Refer to Figure 2.
Installation of MBRP Inc. Performance Exhaust
1. Install the Front Pipe over the existing Y using the 3” Clamp.
Leave all clamps loose enough for adjustment. Refer to Figure 3.
2. Slide the 3” Hanger Clamp over the Extension Pipe or Front
Pipe and install the Muffler onto the Extension Pipe or Front Pipe.
Insert the 3” Hanger Clamp into the existing rubber insulator. Refer
to Figure 4.
Note the Extension Pipe is required on 2010 –Up Crew Cab 8’ box only.
The front pipe will have to be trimmed for the:
2003-Up Regular Cab models (shortened by 20”)
2003-2009 Quad Cab 6’ 4” box (shortened by 20”)
2010- Up Crew Cab 6’ 4” box (shortened by 11”)
Figure 2
Figure 3
Figure 4