MBRP S5306 - Manual (Page 4)

S5306 © 03/13 PAGE 4 OF 4
7. Slide a 2.5” Clamp over the outlet of the passenger side Muffler. Position
the Passenger Side Over Axle Pipe over the axle and loosely attach it to the
Muffler. Loosely attach to the Driver Side Over Axle Pipe using hardware
provided. Refer to Figure 10.
Note, additional 3/8” Flat Washers are provided in case spacing is required
for adjustments.
8. Slide the Passenger Side Tail Pipe onto the Passenger Side Over Axle
Pipe installing the hanger to the existing rubber insulator. Refer to
Figure 11.
9. Install and adjust the Exhaust Tips to suit. Using a 17mm wrench tighten
the lock bolt located on each Exhaust Tip.
10. Align the exhaust as required. Starting at the front of the vehicle exhaust,
tighten all clamps and connections.
11. Check along the whole length of the exhaust system to ensure that there is
adequate clearance around the spare tire, fuel and brake lines.
Congratulations! You are ready to begin experiencing the improved power, sound and driving experience of
your MBRP Inc. performance exhaust system. We know you will enjoy your purchase.
Figure 10
Figure 11