MBRP S5404 - Manual (Page 2)

S5404 © 03/13 PAGE 2 OF 3
2007-2013 Nissan Titan
Removal of Stock System
1. Apply a penetrating lubricant liberally to all exhaust
fasteners, hangers and rubber insulators.
2. Remove the nuts from the exhaust flanges behind the
catalytic converters. Refer to Figure 1.
3. Remove the existing exhaust hanger. Refer to Figure 2.
4. Lubricate then remove the hardware from the rearmost
exhaust hanger. Keep for reinstallation. Refer to Figure 3.
5. Remove the hardware from the flange behind the muffler.
Remove the hanger from the rubber insulator and remove the
exhaust from the vehicle.
Installation of MBRP Inc. Performance Exhaust
1. Install the Driver Side Extension Pipe using one of the
provided 2 ½” Gaskets and existing hardware whenever possible.
The nuts can be replaced with the 10mm Flange Nuts. Leave
hardware loose enough for some adjustment. Refer to Figure 4.
2. Slide a 2 ½” Clamp over the Intermediate Pipe and install it
to the Driver Side Front Pipe.
3. Slide the existing factory hanger onto the Extension Pipe and
reattach it to the vehicle. Refer to Figure 5.
4. Install the Passenger Side Extension Pipe using a 2 ½”
Gasket and existing hardware whenever possible. The nuts can be
replaced with the 10mm Flange Nuts. Leave hardware loose
enough for some adjustment.
5. Slide two 2 ½” Clamps onto the Muffler and attach it to the
Passenger Side Extension Pipe and the Intermediate Pipe.
Leave the 2 ½” Clamps loose enough for some adjustment.
Refer to Figure 6.
Figure 1
Figure 2
Figure 3
Figure 4
Figure 5