MBRP S5066 - Manual (Page 3)

S5066 © 03/11 PAGE 3 OF 4
2. Slide a 3” Hanger Clamp onto the rear of the Extension Pipe. Install the
Muffler onto the Extension Pipe. Refer to Figure 5. Note: the shorter 3”
Hanger Clamp will be used on 2010 models.
3. Slide a 2 ½”Clamp onto the Passenger Side Over Axle Pipe and insert onto
the passenger side of the Muffler. Attach the hanger to the factory rubber
insulator.
4. Slide a 2 ½”Clamp onto the Driver Side Over Axle Pipe and insert onto the
driver side of the Muffler. Attach the hanger to the factory rubber insulator.
Refer to Figure 7.
5. Slide the Driver Side Tail Pipe hanger into the rearmost rubber insulator and
attach it to the frame. Slide a 2 ½”Clamp onto the Driver Side Tail Pipe and
then attach it to the Driver Side Over Axle Pipe. Refer to Figure 8.
6. Slide a 2 ½”Clamp onto the Passenger Side Tail Pipe and then attach it to
the Passenger Side Over Axle Pipe. Using the hardware provided attach the
Hanger Assembly to the bottom of the frame. Refer to Figure 9.
Figure 5
Figure 6
Figure 7
Figure 8
Figure 9