MBRP S5066 - Manual (Page 2)

S5066 © 03/11 PAGE 2 OF 4
Removal of Stock System
1. Apply a penetrating lubricant liberally to all exhaust fasteners, hangers
and rubber insulators.
2. Remove the clamp behind the catalytic converter and save the clamp
for the installation. Refer to Figure 1.
3. Cut the tail pipe to allow it to clear the rear axle during removal.
Refer to Figure 2.
4. Remove the hangers from the rubber insulators and remove the exhaust from
the vehicle. Refer to Figure 3.
Installation of MBRP Inc. Performance Exhaust
1. Loosely attach the Extension Pipe to the flange using the stock clamp. Slide
the 3” Hanger Clamp onto the rear of the Extension Pipe and into the
existing rubber insulator. Refer to Figure 4.
Figure 1
Figure 2
Figure 3
Figure 4