MBRP S5506 - Manual (Page 3)

S5506 © 05/08 PAGE 3 OF 3
2. Slide a 2 ¼” Clamp over the Extension Pipe and then install the
Intermediate Pipe to the Extension Pipe. Leave the 2 1/4”Clamp loose
enough for adjustment. Refer to Figure 5.
3. Slide a 2 ¼” Clamp onto the Intermediate Pipe and then install the Muffler
to the Intermediate Pipe. The Muffler hanger fits into the factory rubber
insulator. Refer to Figure 7.
4. Slide the 2 ½”Clamp over the Tail Pipe and install onto the Muffler.
Adjust the Tail Pipe to leave a ½” minimum gap from the bumper fascia.
Refer to Figure 8.
5. Align the exhaust as required. Starting at the front of the exhaust, tighten all
clamps and connections.
6. Check along the whole length of the exhaust system to ensure that there is
adequate clearance around the spare tire, fuel and brake lines or any wiring. If
any interference is detected relocate or adjust.
Congratulations! You are ready to begin experiencing the improved power,
sound and driving experience of your MBRP Inc. performance exhaust system.
We know you will enjoy your purchase.
Figure 5
Figure 6
Figure 7
Figure 8