MBRP S5144 - Manual (Page 3)

S5144 © 12/12 PAGE 3 OF 3
3. Install the second 3” Hanger Clamp. Refer to Figure 5. Install the
Muffler to the Extension Pipe using the 3” Hanger Clamp.
4. Slide two 2 ½” Clamps over the outlets of the Muffler. Position the
Driver Side Over Axle Pipe over the axle and loosely attach it to the
Muffler. Install the Driver Side Over Axle Pipe hanger into the factory
rubber insulator. Repeat these steps for the Passenger Side Over Axle Pipe.
Refer to Figure 6 & 7.
5. Slide a 2 ½” Band Clamp over the Driver Side Over Axle Pipe and
install the Driver Side Tail Pipe. Insert the Driver Side Tail Pipe hanger
into the Rubber Insulator provided. Refer to Figure 8.
6. Slide a 2 ½” Band Clamp over the Passenger Side Over Axle Pipe and
then install the Passenger Side Tail Pipe. Insert the Passenger Side Tail
Pipe hanger into the existing rubber insulator.
6. Install and adjust the Exhaust Tips to suit. Using a 17mm wrench tighten
the lock bolt located on the Exhaust Tips. Refer to Figure 9.
7. Align the exhaust as required. Starting at the front of the exhaust, tighten
all clamps and connections.
8. Check along the whole length of the exhaust system to ensure that there is
adequate clearance around the spare tire, fuel and brake lines or any wiring. If
any interference is detected relocate or adjust.
Congratulations! You are ready to begin experiencing the improved
power, sound and driving experience of your MBRP Inc. performance
exhaust system. We know you will enjoy your purchase.
Figure 5
Figure 6
Figure 7
Figure 8
Figure 9