MBRP S5220 User Manual
Page 3
S5220 © 03/10
PAGE 3 OF 3
2. Slide the 3” Hanger Clamp (short hanger) over the Extension Pipe and
place the hanger into the existing rubber insulator. Refer to Figure 5.
3. Slide the Muffler onto the Extension Pipe and loosely install the 3”
Hanger Clamp (long hanger) into the existing rubber insulator for support.
Refer to Figure 6.
4. Loosely install the Turn Down connecting it to the Muffler outlet through
the 3” Hanger Clamp. Refer to Figure 7.
5. Align the exhaust as required. Starting at the front of the exhaust tighten all
clamps and connections.
6. Check along the whole length of the exhaust system to ensure that there is
adequate clearance around the spare tire, fuel and brake lines or any wiring. If
any interference is detected relocate or adjust.
Congratulations! You are ready to begin experiencing the improved power, sound and driving excitement of your MBRP
Inc. performance exhaust system. We know you will enjoy your purchase.
Figure 5
Figure 6
Figure 7