MBRP S5220 - Manual (Page 2)

S5220 © 03/10 PAGE 2 OF 3
2004-2008 FORD F150
Removal of Stock System:
1. Apply a penetrating lubricant liberally to all exhaust fasteners, hangers and
rubber insulators.
2. Loosen the clamp located behind the “Y” pipe. Refer to Figure 1.
3. Loosen the clamp located in front of the muffler. Refer to Figure 2.
4. Remove the hangers from the rubber insulators and remove the exhaust
from the vehicle. If a hoist or hydraulic lift is not being used the tail pipe may
need to be cut to clear the rear axle. Refer to Figure 3.
Installation of MBRP Inc. Performance Exhaust:
1. Install the Extension Pipe to the end of the “Y” pipe. Refer to Figure 4.
Note: The Extension Pipe will need to be trimmed on some models, refer to
the illustration below.
Figure 1
Figure 2
Figure 3
Figure 4