MBRP S5068 - Manual (Page 3)

S5068 © 07/10 PAGE 3 OF 3
4. Install the Tail Pipe hanger into the factory rubber insulator located
directly above the hanger and attach to the Over Axle Pipe using a 3”
Clamp. Refer to Figure 5.
5. Install and adjust the Exhaust Tip to suit. Using a 17mm wrench tighten
the bolt located on the Exhaust Tip. Refer to Figure 6.
6. Align the exhaust as required before tightening clamps. Starting at the
front of the exhaust tighten all clamps and connections. Check along the
length of the exhaust system to ensure that there is adequate clearance around
the spare tire, fuel and brake lines or any wiring. If any interference is
detected relocate or adjust.
Congratulations! You are ready to begin experiencing the improved power, sound and driving excitement of your
MBRP Inc. performance exhaust system. We know you will enjoy your purchase.
Figure 5
Figure 6