MBRP S5068 - Manual (Page 2)

S5068 © 07/10 PAGE 2 OF 3
07-10 Chevy/GMC Silverado/Sierra 2500HD
Removal of Stock System
1. Apply a penetrating lubricant liberally to all exhaust fasteners,
hangers and rubber insulators.
2. Remove the nuts from the studs holding the front flange together and
disconnect the exhaust system.
3. Remove the hangers from the rubber insulators and remove the exhaust
from the vehicle. Refer to Figure 1.
Installation of MBRP Inc. Performance Exhaust
1. Install the Extension Pipe to the existing flange Attach the hanger to the
rubber insulator located on the frame. Leave the hardware loose enough for
some adjustment. Refer to Figure 2.
2. Slide a 3” Clamp onto the rear of the Extension Pipe Install the Muffler
onto the Extension Pipe using the Hanger Clamp. Refer to Figure 3.
3. Slide a 3” Clamp onto the rear of the Muffler. Feed the Over Axle Pipe
into the rear of the Muffler. Install the hanger on the Over Axle Pipe onto
the existing rubber insulator. Refer to Figure 4.
Figure 1
Figure 2
Figure 3
Figure 4