MBRP S4202 - Manual (Page 3)

S4202 © 07/14 PAGE 3 OF 4
5. Insert the Extension Pipe into the Front Extension Pipe.
Place one 3” Clamp over the Extension Pipe.
Refer to Figure 6.
6. Install the remaining two Rubber Isolators onto the Tail Pipe Assembly.
Refer to Figure 7.
7. It may be necessary to slightly relocate the factory tie down hook on the rear
swing axle. This is easily done with a pry bar placed between the hook and the
trailing arm.
Refer to Figure 8.
8. Install the Tail Pipe Assembly into the Extension pipe and install the
Rubber Isolators onto the vehicle mounting points.
Refer to Figure 9.
Figure 6
Figure 7
Figure 8
Figure 9