MBRP S4600 - Manual (Page 3)

S4600 © 08/13 PAGE 3 OF 3
Installation of MBRP Inc. Performance Exhaust:
1. Use the stock band clamp in combination with the 2 provided 2.25”
clamps to install the Adapter on the Down pipe.
Refer to Figure 2
2. Install the Muffler on to the Adapter previously installed. Place a
3” clamp over the end of the Muffler before installing on Adapter.
Refer to Figure 3
`
3. Loosely install the Over Axle Pipe by inserting it in to the Muffler
outlet. Then move towards the rear of the Over Axle Pipe and install
hangers into all stock rubber isolators.
Refer to Figure 3
4. Slide a 3” Clamp over the expanded end of the Over Axle Pipe just
installed.
Refer to Figure 4
5. Install the Tail Pipe, start at the rear of the vehicle and feed the Tail
Pipe up through the stock pipe location. Some rotation and angle
adjustment will be required to get the pipe successfully over the rear
framework.
Move back under the vehicle once the pipe is through the rear sub frame
and insert it into the Over Axle Pipe.
Refer to Figure 4
6. Install the rear most hanger on the Tail Pipe in to the stock rubber
isolator. Look back over the installed components and make sure that all
parts are clear of sub frame components. If parts are in contact with any
part of the vehicle use spacers to keep them separated while you work
from front to back tightening all Clamps.
7. Now that components are tightened do a final check that the Tail Pipe
is still centered in the stock exhaust outlet location.
8. Finally, install the MBRP Dual Wall Angle Cut Tip on to the Tail
Pipe. Use a 7mm Allen Key to tighten the Tip in your desired location.
Reference Figure 5
Congratulations! You are ready to begin experiencing the improved power, sound and driving excitement of
your MBRP Inc. performance exhaust system. We know you will enjoy your purchase.
Figure 2
Figure 3
Figure 4
Figure 5