MBRP S4600 - Manual (Page 2)

S4600 © 08/13 PAGE 2 OF 3
Removal of Stock System:
1. Apply a penetrating lubricant liberally to all exhaust fasteners, hangers
and rubber insulators.
2. Loosen the band clamp that connects the downpipe to the rest of the
exhaust system.
3. Cut the exhaust system right before the exhaust pipe goes over the rear sub
frame.
Refer to Figure 1
4. Remove the hangers from the rubber insulators and remove the exhaust
from the vehicle. If a hoist or hydraulic lift is not being used the tail pipe
may need to be cut to clear the rear sub frame.
Figure 1