MBRP S5208 User Manual
Page 4

11. Install provided clamps around pipes where needed. Adjust tail pipes to match and check along the whole
length of the exhaust system to ensure that there is adequate clearance around the spare tire, fuel and brake
lines or any wiring. If any interference is detected relocate or adjust.
12. Make sure exhaust is in place before tightening clamps. Start at the front of the exhaust system and begin
tightening all connections.
13. Install and adjust the Tip to suit. Using a 17mm wrench tighten lock bolt located on the Tip.
Congratulations! You are ready to begin enjoying the improved performance and driving experience of your MBRP
Inc. performance exhaust system. We hope you enjoy your purchase.
S5208 ©07/08
Page 4 of 4
- UT6001 (3 pages)
- UT2001 (3 pages)
- UT4001 (4 pages)
- UT8001 (4 pages)
- GM8427 (3 pages)
- GM8425 (3 pages)
- F2313 (2 pages)
- GM8424 (2 pages)
- S6028 (4 pages)
- S6110 (2 pages)
- S6014 (4 pages)
- S6168409 (2 pages)
- S6172409 (2 pages)
- S6210 (4 pages)
- S6132 (3 pages)
- S6002 (4 pages)
- S6122 (4 pages)
- S6106 (3 pages)
- S6006 (5 pages)
- S6162409 (2 pages)
- S6202 (3 pages)
- S6244 (3 pages)
- S6128 (3 pages)
- S6102 (3 pages)
- S6214 (4 pages)
- S6165AL (2 pages)
- S6164AL (2 pages)
- S6206 (4 pages)
- S6100 (3 pages)
- S6167 (3 pages)
- S6166 (3 pages)
- S6156 (2 pages)
- S6157 (2 pages)
- S6150PLM (1 page)
- S6150P (1 page)
- S6150 (4 pages)
- S6224 (3 pages)
- S6020PLM (1 page)
- S6200 (3 pages)
- S6212 (4 pages)
- S6285 (3 pages)
- S6126 (3 pages)
- S6020 (3 pages)
- S6116 (3 pages)
- S6004 (4 pages)