beautypg.com

MBRP S5208 User Manual

Page 3

background image


5. Install the over axle pipe connecting the slip joint to the top outlet on the dual

outlet muffler. Do not tighten allowing for adjustment. See Figure#5

6. Install the “T” hanger-clamp into the two OEM rubber hangers located above the

outlets of the muffler. The “T” hanger-clamp provided is used at this location to
support the exhaust. It is positioned around the over axle pipe and is not used as
a sealing clamp.


7. Connect the driver’s side tail pipe to the over axle pipe. Lift the tail pipe into

approximate position. See Figure #6







8. Using the factory hole located in the frame, found directly above the tail pipe

hanger, attach the rubber hanger provided using the 7/16" nut & bolt supplied.
See Figure #7





9. Hang the tail pipe using the installed rubber hanger. See Figure #8








10. Install the passenger side tail pipe from the rear of the truck, over the axle and

attach to the lower outlet of the muffler. Install tail pipe hanger into the OEM
hanger to complete the driver’s side. See Figure #9












S5208 ©07/08

Page 3 of 4

Figure 5

Figure 6

Figure 7

Figure 9

Figure 8