MBRP S5526 - Manual (Page 2)

S5526 © 01/13 PAGE 2 OF 3
Removal of stock system:
1. Apply a penetrating lubricant liberally to all exhaust fasteners,
hangers and rubber insulators.
2. Loosen the guard below the transfer case and remove. Refer to
Figure 1.
3. Start to remove the exhaust by loosening the clamp just before
the muffler on the driver’s side. Refer to Figure 2.
4. The muffler can be removed by removing the hangers from the
rubber isolators, one on each side. Refer to Figure 3.
5. Loosen the clamp on the extension pipe and remove from the
existing isolators. Refer to Figure 4.
Figure 1
Figure 2
Figure 3
Figure 4