MBRP S8202 - Manual (Page 3)

S8202 © 02/13 PAGE 3 OF 4
5. Mark the bed floor where the T-Pipe is resting. MBRP Inc.
recommends tracing around where the T-Pipe meets the bed floor.
Refer to Figure 4. Remove the Stacks and T-Pipe Assembly from the
bed of the truck. Find the center of the circle traced onto the bed floor,
mark and center punch it. Go under the vehicle and locate the center
punch mark. This marks the location where you are going to cut a hole
for the T-Pipe to pass through the bed of the truck. If you cannot find
the center punch mark use a small drill to create a pilot hole. Make
sure that there is clearance for the
20” Elbow to pass by any frame
cross members. Remove or modify any heat shields that there is
interference with.
6. Cut a hole through the truck bed providing adequate clearance around
the part of the T-Pipe that passes through the truck bed. MBRP Inc.
recommends using a 5” hole saw. It may be required to cut away part
of a bed rail. Refer to Figure 5.
7. Set the T-Pipe Assembly at the desired height from the floor of the
bed (This will set the height of the Stacks). Using spacers to hold the
T-Pipe at the desired height, loosely attach the Stacks to the Stack
Mounting Brackets making sure that they are straight. This will hold
the assembly steady while you line up to the exhaust under the vehicle.
Refer to Figure 6.
8. Install the 3.5” – 4” Adapter with a 3.5” Clamp over the outlet of the
DPF. Pay attention to the alignment of the notch in the 3.5”-4”
Adapter and the pin located on the outlet of the DPF. Ensure that the
Adapter is fully seated. Refer to Figure 7.
9. Install the 4” Hanger Clamp by placing the Plate Mounted Bolt on top
of the cross member with bolt extending down through the hole in the
cross member. Secure the
4” Hanger Assembly with a 3/8” Nut and
3/8” Lock Washer. Refer to Figure 8.
10. Loosely attach the 20” Elbow into the T-Pipe. Install the 4” Hanger
Clamp in the Hanger Assembly and loosely fit it to the horizontal
section of the
20” Elbow. Measure and mark the horizontal section of
the 20” Elbow so that you can use the maximum length of Flex Pipe
and maintain at least 2” of overlap for clamping between the 3.5”-4”
Adapter to the Flex Pipe, and Flex Pipe to
20” Elbow joints. Remove
and cut the 20” Elbow to the required length.
11. Attach the 20” Elbow to the T-Pipe slip joint and then attach the Flex
Pipe to both the 20” Elbow and then 3.5”- 4” Adapter. Be sure to
slide the required Clamps over all joints before fitting pieces together.
12. Make sure the Stack Mounting Brackets are centered on the Stacks
and tighten the fasteners holding the Mounting Brackets to the front
of the truck bed. Tighten all Clamps to ensure your
“Smokers™”
Figure 4
Figure 5
Figure 6
Figure 7
Figure 8