MBRP S6500 - Manual (Page 3)

S6500 © 04/08 PAGE 3 OF 3
2. Slide a 3” Clamp over the Tail Pipe and loosely install the Over Axle
Pipe onto the Tail Pipe. Remove one of the existing rubber insulators
above the axle and install on the hanger located on the vehicle frame.
Refer to Figure 5.
3. Slide a 3” Clamp over the outlet side of the Extension Pipe then slide
it onto the Over Axle Pipe. Refer to Figure 6.
4. Install the Extension Pipe Flange to the existing flange using the
fasteners provided. Refer to Figure 7.
5. Install the hanger for the Over Axle Pipe to the moved existing rubber
insulator. Refer to Figure 8.
6. Install and adjust the Exhaust Tip to suit. Using a 17mm wrench
tighten the lock bolt located on the Exhaust Tip. Refer to Figure 9.
7. Align the exhaust as required. Starting at the front of the exhaust,
tighten all clamps and connections.
8. Check along the whole length of the exhaust system to ensure that
there is adequate clearance around the spare tire, fuel and brake lines or
any wiring. If any interference is detected relocate or adjust.
Congratulations! You are ready to begin experiencing the improved
power, sound and driving experience of your MBRP Inc. performance
exhaust system. We hope you enjoy your purchase.
Figure 5
Figure 6
Figure 7
Figure 8
Figure 9