MBRP S6500 - Manual (Page 2)

S6500 © 04/08 PAGE 2 OF 3
2008 JEEP GRAND CHEROKEE 3.0L DIESEL
Removal of stock system:
1. Apply a penetrating lubricant liberally to all exhaust fasteners,
hangers and rubber insulators.
2. Cut the exhaust above the rear axle to remove.
Refer to Figure 1.
3. Remove the nuts from the studs holding the front flange
together and disconnect exhaust system. Refer to Figure 2.
4. Remove the hangers from the rubber insulators then remove
the exhaust from the vehicle. Refer to Figure 3.
Installation of MBRP Inc. Performance Exhaust:
1. Install the Tail Pipe hanger into the rearmost existing rubber
isolator. Refer to Figure 4.
Figure 1
Figure 2
Figure 3
Figure 4