MBRP S6242TD User Manual
Page 3
S6242TD © 11/10
PAGE 3 OF 3
2. Slide the 3 ½” Clamp over the 3 ½”to 4” Adapter and install it to the
particulate filter. Refer to Figure 4.
3. Slide the 4” Clamp onto the end of the 3 ½”to 4” Adapter and install the
Extension Pipe. Refer to Figure 4.
4. Install the Tail Pipe onto the Extension Pipe using the 4” Clamp Hanger.
Install the hangers into existing rubber insulators. Refer to Figure 5.
5. Install the Exhaust Tip using a 17mm wrench. Align the exhaust as required.
Starting at the front of the exhaust, tighten all clamps and connections.
Refer to Figure 6.
6. Check along the whole length of the exhaust system to ensure that there is
adequate clearance around the spare tire, fuel and brake lines or any wiring. If
any interference is detected relocate or adjust.
Congratulations! You are ready to begin experiencing the improved
performance and driving pleasure of your MBRP Inc. performance exhaust
system. We know you will enjoy your purchase.
Figure 4
Figure 5
Figure 6