MBRP S6242TD - Manual (Page 2)

S6242TD © 11/10 PAGE 2 OF 3
Removal of Stock System:
1. Apply some penetrating lubricant liberally to all exhaust fasteners,
hangers and rubber insulators.
2. Loosen the nut on the band clamp located behind the particulate filter
using a 15mm wrench or socket.
Refer to Figure 1.
3. Cut the exhaust as shown in Figure 2. Remove the muffler and tail
pipe from the OEM rubber insulators. Remove from the vehicle.
Installation of MBRP Inc. Performance Exhaust:
1. The Extension Pipe provided is pre-cut for the crew cab long bed configuration. Cut the Extension Pipe to
the required length for the vehicle being installed to. Refer to Figure 3.
Figure 1
Figure 2
Figure 3