Asus 24x/10x/40x CD-RW Drive CRW-2410S - Manual (Page 15)

ASUS CRW-2410S User’s Manual 15
Setting the Jumper Terminals
Configure the the jumpers to set the device to master or slave mode
before physically installing it to your computer chassis. Use jumper blocks
to short the pins to your desired setting.
CAUTION: Make sure to correctly place the jumper blocks over the
pins. Failure to do so may cause irreparable damage to the drive!
Master Mode
Cover the two pins below the label MA to set the
CD-RW drive as a Secondary Master drive. This is
possible only if your computer supports four IDE
devices. The hard disk in the computer is set as
Primary Master.
Slave Mode
Cover the two pins below the label SL to set the
CD-RW drive as a Slave device if your computer
supports only two IDE devices.
If your computer supports four IDE devices, this
setting sets your CD-RW drive as a Primary Slave
or Secondary Slave.
Cable Select Mode
Cover the two pins below the label CS if your
computer supports a Cable Select (CSEL) signal.
You need an exclusive interface cable for this
setting. Refer to your computer manual for details.
Jumper Terminals