MBRP S6100TD - Manual (Page 3)

S6100TD © 11/10 PAGE 3 OF 3
3. Slide the 4” Hanger Clamp over the inlet of the Muffler. Then install
the Muffler over the Extension Pipe and place the 4” Hanger Clamp
into the OEM rubber hangers above the inlet. (Muffler orientation:
Louver openings should face the rear of the vehicle).
Refer to Figures 4 & 5.
4. Install the Tail Pipe from the rear of the truck, over the axle and
attach to the outlet of the Muffler with 4” Hanger Clamp. Now
install the hangers into the OEM rubber hangers. Refer to Figure 5.
5. Install the remaining Clamps around the pipes where needed. Do not
tighten the Clamps yet.
6. Install and adjust the Exhaust Tip to suit. Using a 17mm wrench
tighten the lock bolt located on the Exhaust Tip. Refer to Figure 6.
7. Align the Tail Pipe and tighten the Clamps starting at the front and
work rearward to secure the system.
8. Check along the full length of the exhaust to ensure there is adequate
clearance for fuel lines, brake lines and any wiring, etc. If any
interference is detected, relocate or adjust.
Congratulations! You are ready to begin experiencing the improved driving pleasure of your MBRP Inc. performance
exhaust system. We know you will enjoy your purchase.
Figure 4
Figure 5
Figure 6