MBRP S6100TD - Manual (Page 2)

S6100TD © 11/10 PAGE 2 OF 3
Removal of Stock System:
1. Separate the stock exhaust system at the slip joint by the muffler.
Remove the rear exhaust from the rubber hangers and remove the
system from under the truck.
2. Using a 15mm socket or wrench, remove the two (2) bolts at the turbo
flange and remove the stock down pipe.
Installation of MBRP Inc. Performance Exhaust:
Note: This exhaust is intended to be used on a lifted vehicle with the spare tire
removed.
1. Install the Down Pipe starting from behind the cross member and place
it in the same position as the stock down pipe. Place the hanger into the
OEM rubber insulator and attaching the flared end to the turbo using
the supplied M10 x 60mm Bolts. Do not fully tighten until all
components are in place. Refer to Figures 1 & 2.
2. Install the 42” Extension Pipe over the Down Pipe. The 42”
Extension Pipe may require cutting to accommodate vehicles other
than the Quad Cab long bed. (Installation tip: Temporarily hang the
Muffler and the 4” Hanger Clamp in place using the two OEM rubber
hangers and measure from the Muffler to the Down Pipe to determine
the length required.) Refer to Figure 3.
Figure 1
Figure 2
Figure 3