MBRP S6104 - Manual (Page 3)

S6104 © 02/11 PAGE 3 OF 3
3. Install the Muffler over the Extension Pipe and into the OEM rubber
hangers. Refer to Figure 4.
4. Remove the factory rubber insulator for the factory tail pipe and install
it onto the Tail Pipe hanger. Install the Tail Pipe from the rear of the
truck, over the axle. Attach it to the outlet of the Muffler and finish
hanging the Tail Pipe by reinstalling the factory insulator.
Refer to Figures 5 & 6.
5.
Install the provided Clamps around the pipes where required.
Refer to Figure 7.
6. Adjust the Tail Pipe and check along the whole length of the exhaust
system to ensure there is adequate clearance around the fuel and brake
lines or any wiring. If any interference is detected relocate or adjust.
7. Install and adjust the Exhaust Tip to suit. Using a 17mm wrench
tighten the lock bolt located on the Exhaust Tip.
Refer to Figure 8.
8. Align the exhaust as required. Starting at the front of the exhaust,
tighten all clamps and connections.
Congratulations! You are ready to begin experiencing the improved
power, sound and driving experience of your MBRP Inc. performance
exhaust system. We hope you enjoy your purchase.
Figure 5
Figure 6
Figure 7
Figure 8