MBRP S6104 - Manual (Page 2)

S6104 © 02/11 PAGE 2 OF 3
Removal of Stock System
1. Apply a penetrating lubricant liberally to all exhaust fasteners,
hangers and rubber insulators.
2. Remove the exhaust system from the rubber insulators and
remove all of the clamps from the system.
3. Separate the slip joint behind the muffler and remove the tail
pipe.
4. Separate the slip joint connecting the down pipe and the
extension pipe. Remove the muffler and extension pipe.
5. Loosen the band clamp connecting the down pipe to the turbo
and remove the down pipe. Do not discard the band clamp as it
is required for the installation. Refer to Figure 1.
Installation of MBRP Inc. Performance Exhaust
1. Install the Down Pipe in the same position as the stock down
pipe by sliding the hanger into the OEM hanger bracket and then
attaching the flared end to the turbo using the stock band clamp. Do
not fully tighten until all components are in place.
Refer to Figure 2.
2. Install the Extension Pipe over the Down Pipe. The Extension
Pipe may require cutting to accommodate vehicles other than the Quad
Cab long bed.
(Installation tip: Temporarily hang the muffler in place using the three
OEM rubber hangers and measure from the muffler to the down pipe to
determine the length required.) Refer to Figure 3.
Figure 1
Figure 2
Figure 3
Figure 4