MBRP S6282 - Manual (Page 3)

S6282 © 07/13 PAGE 3 OF 4
Installation of MBRP Inc. Performance Exhaust:
Filter-back exhaust:
1. The Extension Pipe provided is pre-cut for the crew cab long bed
configuration. Cut the Extension Pipe to the required length for the
vehicle being installed to. Refer to Figure 6.
Figure 6
2. Slide the 3 ½” Clamp over the 3 ½” to 4” Adapter and install it to the
particulate filter. Refer to Figure 7.
3. Slide the 4” Clamp onto the end of the 3 ½” to 4” Adapter and install
the Extension Pipe. Refer to Figure 7.
4. Install the Tail Pipe onto the Extension Pipe. Install the Tail Pipe
hangers into the OEM rubber insulators. The clamp should remain loose
enough for adjustability. Refer to Figure 8.
5. Install the Exhaust Tip using a 17mm wrench. Align the exhaust as
required. Starting at the front of the exhaust, tighten all clamps and
connections.
6. Check along the length of the exhaust system to ensure that there is
adequate clearance around the spare tire, fuel and brake lines or any wiring.
If any interference is detected, relocate or adjust as necessary.
Down pipe:
7. Install the Upper Pipe in the reverse order of removing the upper section
of the OEM pipe. Again, it is tight, but it will fit. Once the Upper Pipe is in
position, loosely install the OEM V-band Clamp. See Figure 9.
8. Install the Lower Pipe by first sliding the supplied 4” Band Clamp over
the pipe then sliding it onto the Upper Pipe. Do not tighten yet.
Figure 7
Figure 8
Figure 9
Figure 10