MBRP S6242 User Manual
Page 3
S6242 © 02/10
PAGE 3 OF 3
2. Slide the 3 ½” Clamp over the 3 ½”to 4” Adapter and install it to the
particulate filter. Refer to Figure 4.
3. Slide the 4” Clamp onto the end of the 3 ½”to 4” Adapter install the
Extension Pipe. Refer to Figure 4.
4. Install the Tail Pipe onto the Extension Pipe. Install the Tail Pipe
hangers into the OEM rubber insulators. The clamp should remain loose
enough for adjustability. Refer to Figure 5.
5. Install the Exhaust Tip using a 17mm wrench. Align the exhaust as
required. Starting at the front of the exhaust, tighten all clamps and
connections.
6. Check along the whole length of the exhaust system to ensure that
there is adequate clearance around the spare tire, fuel and brake lines or
any wiring. If any interference is detected relocate or adjust.
Congratulations! You are ready to begin experiencing the improved power, sound and driving experience of
your MBRP Inc. performance exhaust system. We hope you enjoy your purchase.
Figure 4
Figure 5