MBRP S6200 - Manual (Page 3)

7. Install the provided Clamps around the pipes where required. Adjust the Tail Pipe and check along the
whole length of the exhaust system to ensure that there is adequate clearance around the fuel and brake
lines or any wiring. If any interference is detected relocate or adjust.
8. Ensure that the exhaust is in place before tightening clamps. Start at the front of the exhaust system and
begin tightening all connections.
9. Install and adjust the Tip to suit. Using a 17mm wrench tighten lock bolt located on the Tip.
Congratulations! You are ready to begin enjoying the improved performance and driving experience of your
MBRP Inc. performance exhaust system. We hope you enjoy your purchase.
S6200 © 05/09 PAGE 3 OF 3