MBRP S6102 - Manual (Page 2)

S6102 © 07/11 PAGE 2 OF 3
Removal of Stock System:
1. Separate the stock exhaust system at the slip joint by the muffler.
Remove the rear exhaust from the rubber hangers and remove the
system from under the truck.
2. Using a 15mm socket or wrench, remove the two (2) bolts at the turbo
flange and remove the stock system.
Installation of MBRP Inc. Performance Exhaust:
1. Install the Down Pipe starting from behind the cross member and
place it in the same position as the stock down pipe. Place the
hanger into the OEM rubber insulator and attaching the flared end
to the turbo using the supplied M10 x 60mm Bolts. Do not fully
tighten until all components are in place. Refer to Figures 1 & 2.
2. Install the Extension Pipe over the Down Pipe. The Extension
Pipe may require cutting accommodate vehicles other than the
Quad Cab long bed. (Installation tip: Temporarily hang the
Muffler into the two OEM rubber hangers and measure from the
muffler to the Down Pipe to determine the length required.)
Refer to Figure 3.
Figure 1
Figure 2
Figure 3