MBRP S6006 - Manual (Page 4)

S6006 © 06/09 PAGE 4 OF 5
7. Install the Over Axle Pipe onto the top outlet of the Muffler and
install the hanger into the OEM rubber hanger located above the
Muffler. Adjust for maximum axle clearance. See Figure 10.
8. Install the Driver Side Tailpipe by feeding it around the outside of
the shock absorber and connecting it to the Over Axle Pipe.
Adjust for maximum clearance around shock absorber. See Figure
11.
9. Using the factory hole located in the frame, found directly above
the tail pipe hanger, attach the Rubber Hanger provided using the
supplied hardware. See Figure 12. Hang the Driver’s Side
Tailpipe from the installed Rubber Hanger.
10. Install the Passenger Side Tail Pipe from the rear of the truck,
over the axle and attach to the lower outlet of the Muffler. Install
the tail pipe hanger into the OEM hanger and adjust for maximum
axle clearance to complete. See Figure 13.
11. Install the remaining Clamps around pipes as shown in the
opening diagram. Adjust the Tailpipes and check along the whole
length of the exhaust system to ensure that there is adequate
clearance around the spare tire, fuel and brake lines or any wiring.
If any interference is detected, relocate or adjust.
12. Make sure the exhaust is properly aligned before tightening
clamps. Start at the front of the exhaust system and begin
tightening all connections.
13. Install and adjust Tips to suit. Using a 17mm wrench tighten lock
bolt located on each Tip.
Figure 10
Figure 11
Figure 12
Figure 13