MBRP S6202 - Manual (Page 3)

6. Install the Passenger Side Tail Pipe from the rear of the truck, over the axle passing through the T-
Hanger Clamp and attach to the upper outlet of the Muffler. Install the tail pipe hanger into the OEM
hanger to complete the passenger side.
7. Connect the Driver’s Side Tail Pipe to the Over Axle Pipe. Lift the Driver’s Side Tail Pipe into
approximate position. Using the factory hole located in the frame, found directly above the tail pipe
hanger, attach the Hanger Kit provided using the 7/16" nut & bolt supplied. Hang the Driver’s Side Tail
Pipe using the installed rubber hanger.
8. Adjust the Tail Pipes accordingly and check along the whole length of the exhaust system to ensure
there is adequate clearance around the fuel and brake lines or any wiring. If any interference is detected
relocate or adjust.
9. Ensure that the exhaust is in place before tightening clamps. Start at the front of the exhaust system and
begin tightening all connections.
10. Install and adjust the Tips to suit. Using a 17mm wrench tighten the lock bolt located on the Tip.
Congratulations! You are ready to begin enjoying the improved power and driving experience of your
MBRP Inc. performance exhaust system. We hope you enjoy your purchase.
S6202 © 03/08 Page 3 of 3