Manley MONO & DUAL MONO TUBE DIRECT INTERFACE MODELS - Manual (Page 4)

CONNECTING YOUR DIRECT INTERFACE
1. Be certain that the unit is switched off.
2. Connect the supplied IEC Mains Cable to the IEC receptacle on the rear of the unit.
3. Connect a 1/4" phone jack marked 'OUT TO AMP' (on the Dual version this is
marked "Unbalanced Output") to your guitar amplifier.
4. Connect a 3 pin female XLR cable from the socket marked 'OUT TO CONSOLE' to
to your console microphone level input. This output is designed to provide a direct feed from
the Tube-Direct Interface to a micpre input. Thus you can later mix in this feed with the
guitar amp mic'ed cabinet. Do NOT supply phantom power to this output!!
5. Connect your instrument's output to the Instrument Input on the front panel. Electric
Guitar, bass, keyboards, etc.
6. Turn on the power and allow the unit several minutes to 'warm up' before opening the
gain on your amplifier.
7. Go for it!
0
-1
-2
-3
-4
-5
-6
-7
-8
-9
-10
-11
-12
-13
-14
-15
FREQUENCY RESPONSE OF "EQ SWITCH" SETTING