beautypg.com

Introduction, Warning – Manley MONO & DUAL MONO TUBE DIRECT INTERFACE MODELS User Manual

Page 3

background image

INTRODUCTION

WATER & MOISTURE
As with any electrical equipment, this unit should not be used near water or moisture.
SERVICING
The user should not attempt to service this unit beyond that described in the owner's manual. Refer all servicing other
than tube replacement to Manley Laboratories.

WARNING!

TO PREVENT THE RISK OF ELECTRIC SHOCK

DO NOT OPEN THE CABINET

REFER SERVICING TO

QUALIFIED PERSONEL

!

THANK YOU!...
for choosing the Manley Laboratories Tube-Direct Interface. This manual covers both mono and dual-mono (stereo)
units. Please take a few moments to read through this manual.

LOCATION & VENTILATION
The Tube-Direct Interface must be installed in a stable location with ample ventilation. It is recommended that you
allow enough clearance on the top and bottom of the unit such that a constant flow of air can flow through the ventilation
slots.

MAINS CONNECTIONS

Your Tube-Direct Interface has been factory set to the correct mains voltage for your country. The voltage setting is
marked on the rear panel. Check that this complies with your local supply.

Export units for certain markets have a moulded mains plug fitted to comply with local requirements. If your power cord
does not have the appropriate plug fitted the coloured wires should be connected to the appropriate plug terminals in
accordance with the following code.

GREEN/YELLOW

EARTH

terminal

BLUE

NEUTRAL

terminal

BROWN

LIVE

terminal

As the colours of the wires in the mains lead may not correspond with the coloured marking identifying the terminals in
your plug proceed as follows;

The wire which is coloured GREEN/YELLOW must be connected to the terminal in the plug which is marked by the
letter E or by the safety earth symbol or coloured GREEN or GREEN and YELLOW.

The wire which is coloured BLUE must be connected to the terminal in the plug which is marked by the letter N or
coloured BLACK.

The wire which is coloured BROWN must be connected to the terminal in the plug which is marked by the letter L or
coloured RED.

DO NOT CONNECT/SWITCH ON THE MAINS SUPPLY UNTIL ALL OTHER CONNECTIONS HAVE
BEEN MADE.