King of Fans Belmont - Manual (Page 3)

READ AND SAVE THESE INSTRUCTIONS
1. To reduce the risk of electric shock, insure electricity has
been turned off at the circuit breaker or fuse box before
beginning.
2. All wiring must be in accordance with the National
Electrical Code (ANSI / NFPA 70-1999 ) and local
electrical codes. Electrical installation should be
performed by a qualified licensed electrician.
3. CAUTION: To reduce the risk of personal injury, use only
the screws provided with the outlet box.
4. The outlet box and support structure must be securely
mounted and capable of reliably supporting a minimum of
35 pounds. Use only UL Listed outlet boxes marked "FOR
FAN SUPPORT."
WARNING
TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK OR PERSONAL
INJURY, MOUNT FAN TO OUTLET BOX MARKED ACCEPTABLE FOR
FAN SUPPORT WITH THE SCREWS PROVIDED WITH THE OUTLET
BOX.
5. The fan must be mounted with a minimum of 7 feet
clearance from the trailing edge of the blades to the floor.
6. Avoid placing objects in the path of the blades.
7. To avoid personal injury or damage to the fan and other
items, be cautious when working around or cleaning the
fan.
8. Do not use water or detergents when cleaning the fan or
fan blades. A dry dust cloth or lightly dampened cloth
will be suitable for most cleaning.
1.Safety Rules
9. After marking electrical connections, spliced conductors
should be turned upward and pushed carefully up into outlet
box. The wires should be spread apart with the grounded
conductor and the equipment-grounding conductor on one
side of the outlet box.
NOTE: The important safeguards and instructions
appearing in this manual are not meant to cover all possible
conditions and situations that may occur. It must be
understood that common sense, caution and care are factors
which can not be built into this product. These factors must
be supplied by the person(s) installing caring for and
operating the unit.
This Fan is suitable for wet location. Suitable for Use In
Wet Locations When Installed In A GFCI Protected
Branch Circuit.
Use only with light with light kits marked"Suitable for
use in wet locations".
WARNING
TO REDUCE THE RISK OF PERSONAL INJURY, DO NOT BEND THE
BLADE BRACKETS (ALSO REFERRED TO AS "FLANGES") DURING
ASSEMBLY OR AFTER INSTALLATION. DO NOT INSERT OBJECTS IN
THE PATH OF THE BLADES.
WARNING
TO REDUCE THE RISK OF SHOCK. THIS FAN MUST BE INSTALLED
WITH AN ISOLATION CONTROL/SWITCH. TO REDUCE THE RISK OF
FIRE OR ELECTRIC SHOCK, THIS FAN SHOULD ONLY BE USED WITH
FAN SPEED CONTROL PART NO.UC-7067RC, MANUFACTURED BY
RHINE ELECTRIC CO., LTD.