Innovate Motorsports MTX-D, Water Temperature/Volt Gauge - Manual (Page 8)

- 8 -
7. Once LogWorks launches go to File->Connect. You will be prompted to connect to serial
COM port. Click Connect.
8. To start recording go to File->New Real-time Log or, in the Toolbar, click on the Tool.
5 Changing the MTX gauge face and/or bezel
1. Lay the MTX gauge face down and remove the three #2 phillips screws from the outside
rim of the back plate.
2. Carefully lift out the bezel from the gauge cup.
3. Configure the gauge as desired by changing the gauge face and or bezel.
*Be sure to remove protective film from the gauge face. This can be done easily
with a piece of scotch tape.
4. Make sure every piece is positioned correctly using the locating tab and reassemble the
gauge.
5. Reinstall the 3 #2 phillips screws.