Demon Fuel Systems 421440 - Manual (Page 5)

5
Figure 9 Figure 10
10. Install the electric choke pod. Use one of the 1-3/4" Allen screws with a #8 lock washer in the
upper left mounting hole to hold the pod in place while you make the other connections. Insert the
end of the choke rod through the hole in the end plate of the pod, with the end of the plastic cam
above the rod where it comes through the hole in the bracket.
Use the 1/2” cotter key to secure
the choke rod in place (Fig. 11). Install the remaining two 1-3/4" Allen screws with #8 lock washers
on the choke pod. Before tightening the mounting screws open the throttle linkage with the
primary throttle linkage and push the adjuster on the side of the choke pod forward. The choke
flap shop should be open to the vertical position and the fast idle speed screw should be inline
with, but not touch the plastic fast idle cam. If it does not align with the cam it may be necessary to
slightly bend the bracket to line it up properly.
Figure 11
11. It is now necessary to re-install the vacuum pod if it was removed in step one (Fig. 12). Simply
reverse the removal process. Don't forget the sealing o-ring.