DECO BREEZE Adjustable Height Floor Fan - Manual (Page 4)

3
10. Reattach the black plastic locking nut
by screwing clockwise until firmly
tightened.
11. Loosen the set screw on the fan blade assembly. (see Picture C)
12. Remove and discard the black protective covering from the fan
motor pin.
13. Slide the fan blade assembly onto the motor pin until flush with
the end of the pin and tighten the set screw securely. (see Picture
C)
14. On the outside edge of the front fan grill, open the 4 fan grill
clamps so they are positioned perpendicular to the grill.
15. Attach the front grill assembly to the rear grill assembly by
locking the top “fork” edge, then swing down and affix with the
metal clamps.
16. You are now ready to enjoy your fan!
Fan Use
1. The speed selector switch is located on the back of the motor
housing. To operate, simply twist the knob to the desired setting.
Your fan features 3 speed settings (I – Lowest Speed, II –
Medium Speed, III – Highest Speed). 0 – Fan is turned off.
2. The fan can operate in a stationary or an oscillating mode. To
shift between modes, simply pull up or depress the Oscillation
Button located next to the speed switch on the fan motor.
3. You can adjust the angle of your fan by adjusting the tilt
adjustment screw underneath the fan motor at the base. Be sure
to firmly tighten the screw when the desired angle is achieved.
Care & Cleaning
1. Always turn your fan to the off position prior to cleaning.
2. Clean parts with a duster or damp cloth. Prior to resuming use,
make sure all moisture is dry.
3. Do not immerse in any type of liquid or use abrasive cleaning
solutions.
4. Use care around the motor housing as no excessive moisture or
liquid should come in contact with the motor housing or its parts.
5. When storing your fan, make sure to place in a dry environment.
To reduce dust and particle exposure, it is best to cover your fan
– especially in the off-season period.